smartctl 7.4 2023-08-01 r5530 [FreeBSD 14.0-RELEASE-p5 amd64] (local build)
Copyright (C) 2002-23, Bruce Allen, Christian Franke, [URL="http://www.smartmontools.org"]www.smartmontools.org[/URL]
=== START OF INFORMATION SECTION ===
Model Family: Seagate Barracuda 7200.12
Device Model: ST31000528AS
Serial Number: 6VPD48MX
LU WWN Device Id: 5 000c50 036c1e5d4
Firmware Version: CC46
User Capacity: 1,000,204,886,016 bytes [1.00 TB]
Sector Size: 512 bytes logical/physical
Rotation Rate: 7200 rpm
Device is: In smartctl database 7.3/5528
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 2.6, 3.0 Gb/s
Local Time is: Sun Apr 7 22:59:29 2024 EDT
==> WARNING: A firmware update for this drive may be available,
see the following Seagate web pages:
[URL unfurl="true"]http://knowledge.seagate.com/articles/en_US/FAQ/207931en[/URL]
[URL unfurl="true"]http://knowledge.seagate.com/articles/en_US/FAQ/213891en[/URL]
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART Status not supported: Incomplete response, ATA output registers missing
SMART overall-health self-assessment test result: PASSED
Warning: This result is based on an Attribute check.
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 609) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 176) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x103f) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 114 099 006 Pre-fail Always - 77185527
3 Spin_Up_Time 0x0003 094 094 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 099 099 020 Old_age Always - 1369
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0
7 Seek_Error_Rate 0x000f 087 060 030 Pre-fail Always - 4948635329
9 Power_On_Hours 0x0032 038 038 000 Old_age Always - 55175
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 532
183 Runtime_Bad_Block 0x0032 100 100 000 Old_age Always - 0
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 084 084 000 Old_age Always - 16
188 Command_Timeout 0x0032 100 099 000 Old_age Always - 4295032836
189 High_Fly_Writes 0x003a 076 076 000 Old_age Always - 24
190 Airflow_Temperature_Cel 0x0022 084 048 045 Old_age Always - 16 (Min/Max 16/16)
194 Temperature_Celsius 0x0022 016 052 000 Old_age Always - 16 (0 14 0 0 0)
195 Hardware_ECC_Recovered 0x001a 052 019 000 Old_age Always - 77185527
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 3
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 3
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 56623 (136 61 0)
241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 2282680202
242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 2664697217
SMART Error Log Version: 1
ATA Error Count: 15 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 15 occurred at disk power-on lifetime: 55175 hours (2298 days + 23 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 f8 03 31 0c Error: UNC at LBA = 0x0c3103f8 = 204538872
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 c8 68 51 31 4c 00 00:09:02.693 READ FPDMA QUEUED
60 00 18 68 40 31 4c 00 00:09:02.691 READ FPDMA QUEUED
60 00 08 90 33 31 4c 00 00:09:02.686 READ FPDMA QUEUED
60 00 10 b0 31 31 4c 00 00:09:02.682 READ FPDMA QUEUED
60 00 88 88 03 31 4c 00 00:09:02.679 READ FPDMA QUEUED
Error 14 occurred at disk power-on lifetime: 55168 hours (2298 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 68 1e 31 0c Error: UNC at LBA = 0x0c311e68 = 204545640
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 42 80 00 1e 31 4c 00 00:52:59.806 READ DMA EXT
25 42 80 80 1d 31 4c 00 00:52:59.803 READ DMA EXT
25 42 80 00 1d 31 4c 00 00:52:59.802 READ DMA EXT
25 42 80 80 1c 31 4c 00 00:52:59.800 READ DMA EXT
25 42 80 00 1c 31 4c 00 00:52:59.798 READ DMA EXT
Error 13 occurred at disk power-on lifetime: 55168 hours (2298 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 f8 03 31 0c Error: UNC at LBA = 0x0c3103f8 = 204538872
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 42 80 80 03 31 4c 00 00:52:56.826 READ DMA EXT
25 42 80 00 03 31 4c 00 00:52:56.824 READ DMA EXT
25 42 80 80 02 31 4c 00 00:52:56.822 READ DMA EXT
25 42 80 00 02 31 4c 00 00:52:56.820 READ DMA EXT
25 42 80 80 01 31 4c 00 00:52:56.818 READ DMA EXT
Error 12 occurred at disk power-on lifetime: 55168 hours (2298 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 d0 fb 30 0c Error: UNC at LBA = 0x0c30fbd0 = 204536784
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 42 80 80 fb 30 4c 00 00:52:53.990 READ DMA EXT
25 42 80 00 fb 30 4c 00 00:52:53.987 READ DMA EXT
25 42 80 80 fa 30 4c 00 00:52:53.986 READ DMA EXT
25 42 80 00 fa 30 4c 00 00:52:53.984 READ DMA EXT
25 42 80 80 f9 30 4c 00 00:52:53.982 READ DMA EXT
Error 11 occurred at disk power-on lifetime: 55167 hours (2298 days + 15 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 f8 03 31 0c Error: UNC at LBA = 0x0c3103f8 = 204538872
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 c8 68 51 31 4c 00 00:07:12.783 READ FPDMA QUEUED
60 00 08 90 33 31 4c 00 00:07:12.781 READ FPDMA QUEUED
60 00 88 88 03 31 4c 00 00:07:12.777 READ FPDMA QUEUED
60 00 b0 10 d3 30 4c 00 00:07:12.776 READ FPDMA QUEUED
60 00 38 d0 92 30 4c 00 00:07:12.767 READ FPDMA QUEUED
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 21129 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
The above only provides legacy SMART information - try 'smartctl -x' for more