I'm experimenting with a dual monitor setup.
I have a 7600GT card, one flash new BenQ monitor, and one old Viewsonic.
If I plug them both in to my graphics card and boot up both screens display the same thing while on the command line.
As soon as I start XOrg only one turns on however. What is bothering me though, is the output of xrandr:
I'm not seeing the outputs I'm expecting: DVI-0, DVI-1 etc. So the problem seems to be with the outputs from the graphics card. Anyone have any ideas what I should try next?
I have a 7600GT card, one flash new BenQ monitor, and one old Viewsonic.
If I plug them both in to my graphics card and boot up both screens display the same thing while on the command line.
As soon as I start XOrg only one turns on however. What is bothering me though, is the output of xrandr:
Code:
> xrandr -q
Screen 0: minimum 320 x 240, current 1920 x 1080, maximum 1920 x 1080
default connected 1920x1080+0+0 0mm x 0mm
1920x1080 50.0*
1680x1050 51.0
... <truncated>
I'm not seeing the outputs I'm expecting: DVI-0, DVI-1 etc. So the problem seems to be with the outputs from the graphics card. Anyone have any ideas what I should try next?