I
iic2
Guest
First I want to thank DutchDaemon and vivek for the help in my previous post. I tried to thank them but out of 6 times of trying to reply I got:
The website is unable to display the webpage
HTTP 501/HTTP 505
What you can try:
Go back to the previous page.
This never happen before. Opera and IE-7 So this is my next move to see what happen (New Post). I Hope i'm posting under the right section.
When I installed freeBSD I only installed Disk 1 and no port system cause I want to keep my install as small as possible. Now I am ready to start installing stuff. For now I only going to install Perl. I downloaded:
gzip-1.2.4.tar
gzip-1.2.4.tar.Z
perl-5.10.0.tar.gz
Which gzip is recommended and do I have to install it first in-order to install perl? Since I did not install any parts of the port system do I have everything needed anyway? And finally what command line am I'm suppose to use? I want to install nearly everything I need into one folder /usr/myhome/perl and usr/myhome/gzip . I'm trying to avoid going to deep into folders and to keep everything in one place.
Since installing freeBSD the only thing I done was practice backup and running around the system to get use to it, but now I can't find no information on how to install programs manually and I'm afraid to move on cause I don't want to make any mistakes and regret not installing the port system. I read some where about one port at a time but that was the only one and I lost the link. Once I'm sure of the manual-installing sequence I guest I can use near the same for everything else then I'll be alright for a while. I need to learn how to do it by hand and not on the internet.
Thanks in advance again
The website is unable to display the webpage
HTTP 501/HTTP 505
What you can try:
Go back to the previous page.
This never happen before. Opera and IE-7 So this is my next move to see what happen (New Post). I Hope i'm posting under the right section.
When I installed freeBSD I only installed Disk 1 and no port system cause I want to keep my install as small as possible. Now I am ready to start installing stuff. For now I only going to install Perl. I downloaded:
gzip-1.2.4.tar
gzip-1.2.4.tar.Z
perl-5.10.0.tar.gz
Which gzip is recommended and do I have to install it first in-order to install perl? Since I did not install any parts of the port system do I have everything needed anyway? And finally what command line am I'm suppose to use? I want to install nearly everything I need into one folder /usr/myhome/perl and usr/myhome/gzip . I'm trying to avoid going to deep into folders and to keep everything in one place.
Since installing freeBSD the only thing I done was practice backup and running around the system to get use to it, but now I can't find no information on how to install programs manually and I'm afraid to move on cause I don't want to make any mistakes and regret not installing the port system. I read some where about one port at a time but that was the only one and I lost the link. Once I'm sure of the manual-installing sequence I guest I can use near the same for everything else then I'll be alright for a while. I need to learn how to do it by hand and not on the internet.
Thanks in advance again