Got myself a cheap wifi stick
rtwn0: <altek 802.11n WLAN Adapter, class 0/0, rev 2.00/2.00, addr 7> on usbus0
ifconfig wlan0 list caps
drivercaps=591c541<STA,FF,IBSS,HOSTAP,SHSLOT,SHPREAMBLE,MONITOR,WPA1,WPA2,WME>
cryptocaps=b<WEP,TKIP,AES_CCM>
htcaps=7002c<SHORTGI20>
Followed the handbook on setting an access point (33.3.6.3), wlan0 is up and looks good.
When I try to connect with an Android tablet, it can log in to the wlan, password is accepted, but then it's stuck at Obtaining IP Address.
I guess the handbook is missing a routing part there and I need a bridge.
For bhyve, already have bridge0 with tap0 and re0.
How would one configure a bridge with re0 and wlan0, too?
When I try to add re0 to a second bridge1 I get
ifconfig bridge1 addm re0
ifconfig: BRDGADD re0: Device busy
The FreeBSD box gets dhpc from a Fritz internet router.
(FreeBSD 13.1-RELEASE-p3 GENERIC amd64)
rtwn0: <altek 802.11n WLAN Adapter, class 0/0, rev 2.00/2.00, addr 7> on usbus0
ifconfig wlan0 list caps
drivercaps=591c541<STA,FF,IBSS,HOSTAP,SHSLOT,SHPREAMBLE,MONITOR,WPA1,WPA2,WME>
cryptocaps=b<WEP,TKIP,AES_CCM>
htcaps=7002c<SHORTGI20>
Followed the handbook on setting an access point (33.3.6.3), wlan0 is up and looks good.
When I try to connect with an Android tablet, it can log in to the wlan, password is accepted, but then it's stuck at Obtaining IP Address.
I guess the handbook is missing a routing part there and I need a bridge.
For bhyve, already have bridge0 with tap0 and re0.
How would one configure a bridge with re0 and wlan0, too?
When I try to add re0 to a second bridge1 I get
ifconfig bridge1 addm re0
ifconfig: BRDGADD re0: Device busy
The FreeBSD box gets dhpc from a Fritz internet router.
(FreeBSD 13.1-RELEASE-p3 GENERIC amd64)
