Hello. I bought an UPS from a local brand (http://www.atomlux.com.ar/web/UPS-Estabilizador-Controlado-por-Microprocesador-3000.php) It states that can be monitored via software. I checked and there's a version of it for windows and linux (also FreeBSD but too old 3.x) I wanted to try to connect to the UPS using NUT however when I plug the cable to the server (Dell T130, using USB 2.0 ports) I get the following error:
I entered into the BIOS for the server looking for some USB configuration to force it to an old USB version, just in case, but I couldn't find any. Any ideas from where you I start to troubleshoot? I'm going to install the software UPSILON2000 on a Windows machine and try it so to check if it's a FreeBSD related thing. I also tried to connect the cable on a Raspberry Pi3b and it was not detected not even an error.
Code:
[freebsd:/usr/ports/sysutils $]> uname -ar
│FreeBSD freebsd.xsdd.local 12.1-RELEASE-p1 FreeBSD 12.1-RELEASE-p1 GENERIC amd64
│[freebsd:/usr/ports/sysutils $]> dmesg
│usb_alloc_device: set address 3 failed (USB_ERR_IOERROR, ignored)
│usbd_setup_device_desc: getting device descriptor at addr 3 failed, USB_ERR_IOERROR
│usbd_req_re_enumerate: addr=3, set address failed! (USB_ERR_IOERROR, ignored)
│usbd_setup_device_desc: getting device descriptor at addr 3 failed, USB_ERR_IOERROR
│usbd_req_re_enumerate: addr=3, set address failed! (USB_ERR_IOERROR, ignored)
│usbd_setup_device_desc: getting device descriptor at addr 3 failed, USB_ERR_IOERROR
│usbd_req_re_enumerate: addr=3, set address failed! (USB_ERR_IOERROR, ignored)
│usbd_setup_device_desc: getting device descriptor at addr 3 failed, USB_ERR_IOERROR
│usbd_req_re_enumerate: addr=3, set address failed! (USB_ERR_IOERROR, ignored)
│usbd_setup_device_desc: getting device descriptor at addr 3 failed, USB_ERR_IOERROR
│ugen0.3: <Unknown > at usbus0 (disconnected)
│uhub_reattach_port: could not allocate new device
I entered into the BIOS for the server looking for some USB configuration to force it to an old USB version, just in case, but I couldn't find any. Any ideas from where you I start to troubleshoot? I'm going to install the software UPSILON2000 on a Windows machine and try it so to check if it's a FreeBSD related thing. I also tried to connect the cable on a Raspberry Pi3b and it was not detected not even an error.