Solved upgrade 12.2 to 13.0 kernel panic

Hello everyone,

I have an old Proliant DL380 G5 running 12.2-RELEASE with a MBR (BIOS) partition scheme, no swap, no 4k sectors and raiz1 with 6 disks. Upgrading to 13.0-RELEASE results in the following kernel panic:
kernel_panic.jpg


I've spent close to half a day trying to figure out what's going on or how to fix it. According to the release notes there are some changes to the efi boot manager but I'm using MBR so I don' think it's affecting me.

Anyone have any ideas?
 
It seems very similar to PR 241403. Similar because that issue was at least addressed and the value was reported as 0 there. But still, it's very similar. Are you able to test this with the eth link down ?
 
Seems the mlx_load="YES" in /boot/loader.conf driver was causing some issues. If I upgrade without that module it works just fine.
 
Back
Top