Hello,
I have several microcontroller boards that are supposed to appear as storage devices when attached, but don't. This is what I get from dmesg when I plug one of them in:
These boards all work they way they should on Linux, and none of them do on either 11.3 or a fresh install of 12.1. Is there any way to figure out what might be needed to get them working properly on FreeBSD?
Regards,
Denver
I have several microcontroller boards that are supposed to appear as storage devices when attached, but don't. This is what I get from dmesg when I plug one of them in:
Code:
ugen1.3: <Adafruit Industries LLC PyPortal> at usbus1
umodem0 on uhub1
umodem0: <CircuitPython CDC control> on usbus1
umodem0: data interface 1, has no CM over data, has no break
umass3 on uhub1
umass3: <CircuitPython Mass Storage> on usbus1
umass3: SCSI over Bulk-Only; quirks = 0x0000
umass3:5:3: Attached to scbus5
uaudio0 on uhub1
uaudio0: <CircuitPython Audio> on usbus1
uaudio0: No playback.
uaudio0: No recording.
uaudio0: MIDI sequencer.
uaudio0: No HID volume keys found.
ums2 on uhub1
ums2: <CircuitPython HID> on usbus1
ums2: 16 buttons and [XYZ] coordinates ID=2
Regards,
Denver