Hi all,
I'm running FreeBSD 13 on Lenovo Thinkpad T410. I've enabled 915kms module, so far so good.
However, when I plug an HDMI external display to the display port, the screen is not detected. Or better: it is detected at boot, but not after the system is already running. A trick I've found is to switch to a textual console (ALT-F1) and switch back to the video (ALT-F9), at that point the external output is activated.
Is there a way to push the video output to the video port by hitting Fn-F5, the Lenovo keys to do that?
Also, for some reason, if I mirror the external display, it is somehow trimmed on the low side, where I cannot see the bottom of the screen I see on the laptop monitor, even if I try to change the resolution.
Any help is appreciated.
I'm running FreeBSD 13 on Lenovo Thinkpad T410. I've enabled 915kms module, so far so good.
However, when I plug an HDMI external display to the display port, the screen is not detected. Or better: it is detected at boot, but not after the system is already running. A trick I've found is to switch to a textual console (ALT-F1) and switch back to the video (ALT-F9), at that point the external output is activated.
Is there a way to push the video output to the video port by hitting Fn-F5, the Lenovo keys to do that?
Also, for some reason, if I mirror the external display, it is somehow trimmed on the low side, where I cannot see the bottom of the screen I see on the laptop monitor, even if I try to change the resolution.
Any help is appreciated.