source upgrade to 9.0 and now the printer gets reconigzed wrong

R

roelof

Hello,

I do a source upgrade to 9.0. I did:

Code: 
cd /usr/src
make buildworld
make buildkernel
make installkernel
shutdown -r now

After that I choose '4 single user mode' nd the booting begins. But after a while the booting stops at this message:

Code: 
da0 at umass sim0 scbus6 target 0 lun 0 
da0 : <HP Photosmart PLUS 1.00> Removable Direct Acess scsi-5 device
da0 : 40.000 Mb/s transfers
da0 : Attempt to query sze failed : NOT READY : medium not present

It looks to me that the system thinks that my printer is a disk.

Anyone who have a clue how to solve this?

Roelof
 
Can you unplug the printer, boot the machine and plug it back in. I'm wondering what else is detected.

Before plugging in run [cmd=]tail -f /var/log/messages[/cmd] Post every message that gets printed when you plug the printer in.

A lot of modern printers seem to have some sort of storage capacity, this is what may have been detected.
 
The mystery "printer" is a multifunction printer, scanner, copier, coffee maker, clock radio, and card reader. These are from the empty card reader slots.
 
Oke,

I have asked this before but I cannnot find it.
Is there a sort of pasty so I can past it somewhere. I have no DE installed.


My printer is a HP Photosmart Plus
Roelof
 
I have unplugged the printer and did also a start in the single user mode.
But now the booting hangs at the usb-mouse with these messages.
Code: 
ugen 1.2: <LOGITECH> at usbus1
ums0 : <Logitech> USB-PS2 optical mouse class 0/0, rev. 2.00/27.30, addr 2> on usbus1 
ums0 : 8 buttons and {XYZT] coordinates id=0

It looks like there is a problem with USB devices because both printer and mouse are USB devices.
Wierd that the keyboard is detected bacause it's also a UBS-device.
When I see the messages I cannot open any virtual terminals with <crtl> <alt> <Fx>

Roelof
 
It sounds like a problem that really isn't anything to do with USB. Maybe a hard disk controller is waiting to timeout. Could also be an ACPI problem.

Wait a minute...

Sometimes the USB messages in single user mode appear after the prompt. Other virtual ttys aren't available. What happens if you press Enter?
 
When I wait a few minutes and press the enter. I see a prompt appear.
I also see a message that I must enter where sh can be found or press enter. But that message appear before the usb messages about the mouse.

Roelof
 
The USB messages sometimes show up after the prompt. Ignore them. You don't have to wait, just continue on with the next step of the install.
 
Oke,

So if I understand you right I have to do the following steps.
Code: 
mount -u /
mount -u -t ufs
adjkerntz -i 
mergemaster -p 
cd /usr/src
make installworld
mergemaster -p
reboot
 
Sure, if that's the update procedure you're following. The point is just that the USB messages in single-user mode make it look like the computer is doing something when it's just waiting for you.
 
You must log in or register to reply here.
Back
Top