I have a brother 2035, which is basicly the same as the 2030, and so i have followed the instructions of this post.
However, after adding the printer to cups (tried both the #1 USB-option, and the #1 USB (no reset)one without any luck.
Cups will fail to print a test page (will just stand there "processing" the job forever, and when I finally get tired nd cancels it, it will say "printer not connected will retry in 10 seconds". Which becomes 30 seconds after a few tries, but without any luck.
Also, i get the following output from lptest:
dmesg, however, shows
and no problems.
I just don't get it. It is 5:23 in the morning though, and past my bedtime (Watching superbowl and finishing a law paper at the same time wasn't a great idea, now who could have imagined?) so I could be overlooking something stupidly easy, but canøt really imagine why. Hoping for a good tip waiting here when i wake up.
However, after adding the printer to cups (tried both the #1 USB-option, and the #1 USB (no reset)one without any luck.
Cups will fail to print a test page (will just stand there "processing" the job forever, and when I finally get tired nd cancels it, it will say "printer not connected will retry in 10 seconds". Which becomes 30 seconds after a few tries, but without any luck.
Also, i get the following output from lptest:
Code:
[root@osserver ~]# lptest > /dev/unlpt0
bash: /dev/unlpt0: Device busy
[root@osserver ~]# lptest > /dev/ulpt0
bash: /dev/ulpt0: Device busy
dmesg, however, shows
Code:
ugen0.2: <Brother> at usbus0
ulpt0: <Brother HL-2030 series, class 0/0, rev 2.00/1.00, addr 2> on usbus0
ulpt0: using bi-directional mode
I just don't get it. It is 5:23 in the morning though, and past my bedtime (Watching superbowl and finishing a law paper at the same time wasn't a great idea, now who could have imagined?) so I could be overlooking something stupidly easy, but canøt really imagine why. Hoping for a good tip waiting here when i wake up.