Realtek usb to ethernet card not working

Status
Not open for further replies.

anon101

New Member


Messages: 18

I get on bootup:
ure0 on uhub 2
ure0: <Realtek USB 10/100/1000 LAN, class 0/0. rev 3.00/30.00. addr 8> on usbus0
miibus1: <MII bus> on ure0
rgephy1: <RTL8251/8153 1000BASE-T media interface> PHY0 on miibus1
rgephy1: none, 10baseT, 10baseT-FDX, 100baseTX, 1000baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto

My ifconfig output is the following:

My uname -a Output:
FreeBSD MyPC 12.0-RELEASE-p4 FreeBSD 12.0-RELEASE-p4 GENERIC amd64

Btw I wasn't sure whether I should put this here or in peripheral hardware and it's been a couple off days with no luck there (although to be fare I took a while to reply), so I'm posting here too.
Sorry if I've posted in the wrong place
 

k.jacker

Aspiring Daemon

Reaction score: 451
Messages: 740

That's bad practice starting a second thread on exactly the same topic, please don't do that!

Usually, nobody knows the answer to your question. Simple as that.
I see the problem in your thread title. I think people hardly use those usb/ethernet things and thus know little about them.

But, looking at your ifconfig, you havn't configured your network interfaces at all. So the adapter itself doesn't seem to be the "problem".
Configure your interfaces.
 

SirDice

Administrator
Staff member
Administrator
Moderator

Reaction score: 9,382
Messages: 33,987

Don't open multiple threads with the same issue. I'm going to close this one, merging it or leaving this one open will only lead to confusion.
 
Status
Not open for further replies.
Top