Hi. I cannot mount my camera. I have tried on two different computers, one running FreeBSD 9.2 and one running FreeBSD 10.2. I have the same problem on each. This is the log output when it is plugged into the USB port.
But the /dev/da0 device never appears and after a bit of a delay, it starts outputting the following errors.
If I remove the flash card and use internal memory, it creates the /dev/da0 and /dev/da0s1 devices, then starts erroring when I try to mount it. The errors are the same except the numbers are different on the CDB line.
Here is some of the information from
Any help would be appreciated. Let me know if there is any other information I can provide that might help solve the issue.
Code:
ugen7.2: <Panasonic> at usbus7
umass0: <Panasonic DMC-TZ3, class 0/0, rev 1.10/0.10, addr 2> on usbus7
umass0: SCSI over Bulk-Only; quirks = 0x4100
umass0:7:0:-1: Attached to scbus7
da0 at umass-sim0 bus 0 scbus7 target 0 lun 0
da0: <MATSHITA DMC-TZ3 0100> Removable Direct Access SCSI-2 device
da0: 1.000MB/s transfers
da0: 7695MB (15759360 512 byte sectors: 255H 63S/T 980C)
da0: quirks=0x2<NO_6_BYTE>
Code:
(da0:umass-sim0:0:0:0): READ(10). CDB: 28 00 00 f0 77 ff 00 00 01 00
(da0:umass-sim0:0:0:0): CAM status: CCB request completed with an error
(da0:umass-sim0:0:0:0): Retrying command
(da0:umass-sim0:0:0:0): READ(10). CDB: 28 00 00 f0 77 ff 00 00 01 00
(da0:umass-sim0:0:0:0): CAM status: CCB request completed with an error
(da0:umass-sim0:0:0:0): Retrying command
...
Error 5, Retries exhausted
(da0:umass-sim0:0:0:0): got CAM status 0x44
(da0:umass-sim0:0:0:0): fatal error, failed to attach to device
da0 at umass-sim0 bus 0 scbus7 target 0 lun 0
da0: <MATSHITA DMC-TZ3 0100> detached
(da0:umass-sim0:0:0:0): Periph destroyed
Code:
(da0:umass-sim0:0:0:0): READ(10). CDB: 28 00 00 00 00 39 00 00 0c 00 usbconfig.
Code:
idVendor = 0x04da
idProduct = 0x2372
bcdDevice = 0x0010
iManufacturer = 0x0001 <Panasonic>
iProduct = 0x0002 <DMC-TZ3>