Hi all,
I'm having some problems installing FreeBSD 6.3 on my machine equipped with :
Single channel Adaptec® AIC-7901 controller for Ultra320 SCSI
Host RAID 0, 1, 10 support
I have 4 disks which are configured in 2 Raid1,
the problem is when I try to install FreeBSd from the installer cd, it shows only the separated disks.
I've added also ahd_load="YES" into /boot/loader.conf on the installation cd,
also on the boot prompt
load ahd
load ahd.ko
and then boot
but again with no success
.
It were recognized only the 4 disks as separated.
How can I make it recognize the raid ?
Thanks in advance.
I'm having some problems installing FreeBSD 6.3 on my machine equipped with :
Single channel Adaptec® AIC-7901 controller for Ultra320 SCSI
Host RAID 0, 1, 10 support
I have 4 disks which are configured in 2 Raid1,
the problem is when I try to install FreeBSd from the installer cd, it shows only the separated disks.
I've added also ahd_load="YES" into /boot/loader.conf on the installation cd,
also on the boot prompt
load ahd
load ahd.ko
and then boot
but again with no success
. It were recognized only the 4 disks as separated.
How can I make it recognize the raid ?
Thanks in advance.