No IDE support

android6011

New Member


Messages: 4

I am using freenas nightly builds based off of 7.2 and my IDE hard drives and cd rom drive are not detected. I have messed with settings in the bios a ton and have not been able to get them working. Here is the dmesg, anything else i can add just let me know.
My full dmesg is at http://pastebin.com/f1646760c because posting said it was too long, but what appears relevant to me is
Code:
acpi0: reservation of fee00000, 1000 (3) failed
acpi0: reservation of ffb80000, 80000 (3) failed
acpi0: reservation of fec10000, 20 (3) failed
acpi0: reservation of 0, a0000 (3) failed
acpi0: reservation of 100000, 2ff00000 (3) failed
...
#
atapci1: <ATI IXP700 UDMA133 controller> port 0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0xff00-0xff0f at device 20.1 on pci0
The motherboard is This one

Sempron le-1250, 1gb ram,
As far as chipset Northbridge AMD 760G, South Bridge AMD SB710, LAN Realtek 8111C, On board graphics ATI Radeon HD 3000
 

plamaiziere

Active Member

Reaction score: 40
Messages: 184

Hi, could you be more specific about the problem? In your dmesg I see 3 disk: ad4, da0, cd0.

Regards.
 
OP
A

android6011

New Member


Messages: 4

My problem is that no ide device is recognized. it shows up nowhere. the drives that are detected might just be sata drives, I can't remember exactly which ones I had connected when I did dmesg, but I for sure had an ide hard drive and cdrom attached and they don't show up
 

SirDice

Administrator
Staff member
Administrator
Moderator

Reaction score: 9,288
Messages: 33,827

Can you post your kernel config please?
 

DutchDaemon

Administrator
Staff member
Administrator
Moderator
Developer

Reaction score: 2,955
Messages: 11,352

[cmd=]uname -i[/cmd] gives you the name of the kernel config file, and it can be found in /usr/src/sys/$arch/conf/, where $arch is usually 1386 for 32-bit and amd64 for 64-bit installations.
 

daikichi

New Member


Messages: 3

I have the same motherboard (Biostar A760G M2+) and am having the exact same problem. I've been trying to install off of a 02/2009 7-STABLE snapshot CD. The boot loader sees it fine and it boots, but then FreeBSD and thus sysinstall doesn't see the drive. My dmesg is the same, and so I assume this happens with i386/GENERIC. I tried moving stuff around on the board last night before giving up. I'm off to see if I can just install via FTP now...
 
OP
A

android6011

New Member


Messages: 4

Ya I had seen that before. Unfortunately it did not work, I have tried just about every possible combination of settings
 
Top