I have installed FreeBSD 11.1 as a clean install to actual metal. Also have installed cups and placed
into /etc/rc.conf
The printer is a Brother HL-2070N connected to my router by cat5. Currently I am using foomatic as the source of the driver, which is an exact match for the pirnter. The printer can be detected:
The printer also shows up in in localhost:631, and in print dialogues. However printing fails. The jobs do not show up in localhost:631 as failed.
I have also tried gutenprint although with gutenprint I had to choose HL-2060 as HL-2070N wasn't present. This fails in the exact same manner. I just replaced my FreeBSD 11.0 installation on the same setup. Printing was working fine there with gutenprint as the source of the driver.
Code:
cupsd_enable="YES"
The printer is a Brother HL-2070N connected to my router by cat5. Currently I am using foomatic as the source of the driver, which is an exact match for the pirnter. The printer can be detected:
Code:
% lpstat -p
printer HL-2070N is idle. enabled since Sun Jul 30 08:39:39 2017
The printer also shows up in in localhost:631, and in print dialogues. However printing fails. The jobs do not show up in localhost:631 as failed.
I have also tried gutenprint although with gutenprint I had to choose HL-2060 as HL-2070N wasn't present. This fails in the exact same manner. I just replaced my FreeBSD 11.0 installation on the same setup. Printing was working fine there with gutenprint as the source of the driver.