Good morning all,
On an old Dell poweredge 1800 server (from 2006) I installed pfSense as a firewall. It is installed in RAID 1 mode on a PERC 4 controller
Lately one of the records has failed. I found an identical one (make, model, range) and before hot plugging it I was wondering about the reconstruction: will it resume on its own? If so, how to monitor from the OS without rebooting?
I saw that I had to use mfiutil but when I run
I've this message
According to the mfiutil doc, PERC cards are supported from 5 and for the previous ones it is the amr driver that does the job but suddenly I don't know if it's still mfiutil that I should use or another tool to monitor reconstruction.
I add that I don't have a DRAC card and I just have ipmi enabled but it only returns motherboard and chassis info.
Do you have a lead?
Thank you in advance.
P.S .: I know very little about the BSD universe
On an old Dell poweredge 1800 server (from 2006) I installed pfSense as a firewall. It is installed in RAID 1 mode on a PERC 4 controller
Code:
[...]
amr0@pci0:2:5:0: class=0x010400 card=0x05201028 chip=0x19601000 rev=0x01 hdr=0x00
vendor = 'LSI Logic / Symbios Logic'
device = 'MegaRAID'
class = mass storage
subclass = RAID
[...]
Lately one of the records has failed. I found an identical one (make, model, range) and before hot plugging it I was wondering about the reconstruction: will it resume on its own? If so, how to monitor from the OS without rebooting?
I saw that I had to use mfiutil but when I run
Code:
mfiutil show adapter
I've this message
Code:
mfiutil: mfi_open: No such file or directory
According to the mfiutil doc, PERC cards are supported from 5 and for the previous ones it is the amr driver that does the job but suddenly I don't know if it's still mfiutil that I should use or another tool to monitor reconstruction.
I add that I don't have a DRAC card and I just have ipmi enabled but it only returns motherboard and chassis info.
Do you have a lead?
Thank you in advance.
P.S .: I know very little about the BSD universe