An unspecified AI give me this advice but maybe need to do something else before , I hope maybe:
jmicron_load="YES"
hint.jmicron.0.modes="0x1ffa" #force IDE/PATA mode,disable AHCI/SATA quirks
hw.ata.jmicron.enable_pm="0" #disable power management
hw.ata.jmicron.quirks="0x400000000" #ignore timeouts
Until now ,also before this tweak boot sequence stuck when it try to read this device,I don't know if it could be call Kernel panic, but if I extract the adapter/ssd, boot sequence follow without issue,
Thanks in advance for your help/
dmesg -a | grep -B3 sdhci
pcib5: <ACPI PCI-PCI bridge> at device 28.4 on pci0
pci5: <ACPI PCI bus> on pcib5
pci5: <serial bus, FireWire> at device 0.0 (no driver attached)
sdhci_pci0: <JMicron JMB38X SD> mem 0xd9000a00-0xd9000aff irq 16 at device 0.2 on pci5
sdhci_pci0: 1 slot(s) allocated
jmicron_load="YES"
hint.jmicron.0.modes="0x1ffa" #force IDE/PATA mode,disable AHCI/SATA quirks
hw.ata.jmicron.enable_pm="0" #disable power management
hw.ata.jmicron.quirks="0x400000000" #ignore timeouts
Until now ,also before this tweak boot sequence stuck when it try to read this device,I don't know if it could be call Kernel panic, but if I extract the adapter/ssd, boot sequence follow without issue,
Thanks in advance for your help/
dmesg -a | grep -B3 sdhci
pcib5: <ACPI PCI-PCI bridge> at device 28.4 on pci0
pci5: <ACPI PCI bus> on pcib5
pci5: <serial bus, FireWire> at device 0.0 (no driver attached)
sdhci_pci0: <JMicron JMB38X SD> mem 0xd9000a00-0xd9000aff irq 16 at device 0.2 on pci5
sdhci_pci0: 1 slot(s) allocated