Hi.
I have FreeNAS 8.2.0 and had a dead disk. I shut the machine down, pulled the disk and replaced it with a new one and booted it up. I ran the zpool status and got the following:
I have tried to run the following command:
but I get the following error:
I've tried various combinations, but get the same error message. I am now thinking that prior to shutting down the machine, should I have run a command to remove the dead disk. Can anyone verify this and if so, should i put it back, boot it back up and run it, then shut it down and replace the dead one for a new one? After that, what will I see and what would I need to do then?
Many thanks,
Woz.
I have FreeNAS 8.2.0 and had a dead disk. I shut the machine down, pulled the disk and replaced it with a new one and booted it up. I ran the zpool status and got the following:
Code:
[root@gans01] ~# zpool status
pool: z01
state: DEGRADED
status: One or more devices could not be opened. Sufficient replicas exist for
the pool to continue functioning in a degraded state.
action: Attach the missing device and online it using 'zpool online'.
see: [url]http://www.sun.com/msg/ZFS-8000-2Q[/url]
scrub: none requested
config:
NAME STATE READ WRITE CKSUM
z01 DEGRADED 0 0 0
raidz1 DEGRADED 0 0 0
ada0p2 ONLINE 0 0 0
ada1p2 ONLINE 0 0 0
ada2p2 ONLINE 0 0 0
ada3p2 ONLINE 0 0 0
9808651977380028018 UNAVAIL 0 0 0 was /dev/ada4p2
ada5p2 ONLINE 0 0 0I have tried to run the following command:
# zpool replace z01 9808651977380028018 ada6p2but I get the following error:
Code:
cannot open 'ada6p2': no such GEOM provider
must be a full path or shorthand device name.I've tried various combinations, but get the same error message. I am now thinking that prior to shutting down the machine, should I have run a command to remove the dead disk. Can anyone verify this and if so, should i put it back, boot it back up and run it, then shut it down and replace the dead one for a new one? After that, what will I see and what would I need to do then?
Many thanks,
Woz.
