[FreeNAS] Hotswap Issues.

Y

Yar

I'm currently trying to set[]up FreeNAS.. However I'm having issues hotswapping the drives?

I have it set as a RAIDZ2 Volume.

To test hotswap I basically pulled out ada0 whilst the system was on, checked the RAID Status and saw it was "Degraded". So I then placed a new 3 TB into ada0.

Using camcontrol identify ada0 I can see that the system has detected the new disk as it shows the correct serial number. However I cannot use the disk to "Replace" into FreeNAS, and it doesn't appear in "View Disks".

UF0jwib.png


VAKMxYt.png


Using dmesg | grep ada0 I get the following:

YAHOEFS.png



Any suggestions or advice is greatly appreciated.
Hotswap is a necessity for this system..
 
Re: Hotswap Issues.

E04B1wy.png


The replacement drive is showing as pass0,ada0 - Should it be?
 
Re: Hotswap Issues.

Just tried to re-insert the disk and saw
Code: 
Unable to attach new device 0x6
on the monitor.
 
Re: Hotswap Issues.

SirDice said:
Yar said:
I'm currently trying to setup FreeNAS..
Click to expand...
Topics about PC-BSD DesktopBSD FreeNAS NAS4Free m0N0WALL pfSense ArchBSD.

Are those drives connected to the mainboard? I mean is the controller on-board? For some BIOS/UEFI implementations you need to enable hot-swap there.
Click to expand...

Yeah, they're plugged direct to the motherboard, AHCI & Hotplug enabled. I don't think that's an issue though, as camcontrol detects the new drive, it just won't pickup in FreeNAS.
 
You must log in or register to reply here.
Back
Top