Hello everyone. I have been google searching for a couple of days, as well as searching on this forum, and now I am quite stumped . I have a pc with a Broadcom 4318 wireless card, I have enabled the drivers and the firmware. The green LED on my card blinks when I enter
"ifconfig wlan0 up"
However, I cannot connect to my router which has WEP encryption. ( below is are the contents of rc.conf, loader.conf, and wpa_supplicant. The question is continued below that)
contents of /etc/rc.conf
contents of /boot/loader.conf
contents of wpa_supplicant
Whenever I enter the command
it hangs at
I hit ctrl+c and I get this
If I don't hit ctrl+c, ill open up another terminal and type "ifconfig" and the status for "wlan0" will be "associated" instead of "active"
I've tried combinations of things like ifconfig_wlan0="DHCP" to ifconfig_wlan0=" WPA DHCP". However nothing has worked. Also, the output of dmesg shows the following
I'm quite lost, and I don't really know where to go from here. If I need to post any additional information please let me know. Thanks in advance
"ifconfig wlan0 up"
However, I cannot connect to my router which has WEP encryption. ( below is are the contents of rc.conf, loader.conf, and wpa_supplicant. The question is continued below that)
contents of /etc/rc.conf
Code:
hostname="amitbsd.gateway.2wire.net"
ifconfig_wlan0="DHCP"
ifconfig_em0="DHCP"
ipv6_enable="YES"
dbus_enable="YES"
hald_enable="YES"
vaps_bwi0="wlan0"
wlans_bwi0="wlan0"
wpa_supplicant_enable="YES"
wpa_supplicant_conf_file=" /etc/wpa_supplicant.conf"
devfs_system_ruleset="localrules"
Code:
snd_hda_load="YES"
nvidia_load="YES"
if_bwi_load="YES"
bwi_v3_ucode_load="YES"
wlan_wep_load="YES"
wlan_ccmp_load="YES"
wlan_tkip_load="YES"
if_vlan_load="YES"
Code:
network={
key_mgmt=NONE
ssid="2WIRE860"
wep_key3=mykey
wep_tx_keyidx=3
}
wpa_supplicant -i wlan0 -c /etc/wpa_supplicant.conf
it hangs at
Code:
CTRL-EVENT-SCAN-RESULTS
Trying to associate with 00:14:95:c5:d3:81 (SSID='2WIRE860' freq=2422 MHz)
Associated with 00:14:95:c5:d3:81
CTRL-EVENT-CONNECTED - Connection to 00:14:95:c5:d3:81 completed (auth) [id=0 id_str=]
I hit ctrl+c and I get this
Code:
CTRL-EVENT-TERMINATING - signal 2 received
ioctl[SIOCS80211, op 20, len 7]: Can't assign requested address
ioctl[SIOCS80211, op 26, arg 0x0]: Operation not supported
Failed to disable WPA in the driver.
ioctl[SIOCS80211, op 26, arg 0x0]: Operation not supported
ELOOP: remaining socket: sock=4 eloop_data=0x28406140 user_data=0x2840d040 handler=0x8069f40
I've tried combinations of things like ifconfig_wlan0="DHCP" to ifconfig_wlan0=" WPA DHCP". However nothing has worked. Also, the output of dmesg shows the following
Code:
bwi0: need multicast update callback.