e2fsprogs-libuuid fails to build

M

marcelesflores

Hello,

Tried to install e2fsprogs-libuuid from ports today and encountered the following errors:

Code: 
===>  Building for e2fsprogs-libuuid-1.41.8
/bin/mkdir -p /usr/ports/misc/e2fsprogs-libuuid/work/e2fsprogs-1.41.8/lib/uuid/elfshared
cd ./util ; gmake subst
making all in lib/uuid
gmake[1]: Entering directory `/usr/ports/misc/e2fsprogs-libuuid/work/e2fsprogs-1.41.8/util'
	CC subst.c
gmake[1]: Entering directory `/usr/ports/misc/e2fsprogs-libuuid/work/e2fsprogs-1.41.8/lib/uuid'
cd ../../util ; gmake subst
	CC tst_uuid.o
gmake[2]: Entering directory `/usr/ports/misc/e2fsprogs-libuuid/work/e2fsprogs-1.41.8/lib/uuid'
	MKDIR elfshared
gmake[2]: Entering directory `/usr/ports/misc/e2fsprogs-libuuid/work/e2fsprogs-1.41.8/util'
	LD subst
gmake[2]: Leaving directory `/usr/ports/misc/e2fsprogs-libuuid/work/e2fsprogs-1.41.8/lib/uuid'
subst.o: file not recognized: File truncated
gmake[2]: *** [subst] Error 1
gmake[2]: Leaving directory `/usr/ports/misc/e2fsprogs-libuuid/work/e2fsprogs-1.41.8/util'
gmake[1]: *** [../../util/subst] Error 2
gmake[1]: *** Waiting for unfinished jobs....
	CC clear.c
gmake[1]: Leaving directory `/usr/ports/misc/e2fsprogs-libuuid/work/e2fsprogs-1.41.8/lib/uuid'
gmake: *** [all-libs-recursive] Error 1
gmake: *** Waiting for unfinished jobs....
	LD subst
gmake[1]: Leaving directory `/usr/ports/misc/e2fsprogs-libuuid/work/e2fsprogs-1.41.8/util'
*** Error code 1

Stop in /usr/ports/misc/e2fsprogs-libuuid.
*** Error code 1

Stop in /usr/ports/misc/e2fsprogs-libuuid.

This on a 7.1 install with an up-to-date ports tree. Any idea what might be happening here? Thanks very much!

-m
 
I had a failure too yestarday while updating, but I can't remember if the error was the same.
Anyway I just changed to the port directory, and after a make clean the ports has been updated successfully.
I hope it will work for you too.

EDIT:
Can you try building it using MAKE_JOBS_UNSAFE ?
 
Maybe I'm wrong, but I suspected it was the problem because the error message says "file not recognized: File truncated".
I had an error as well, and even if not sure about mine and that it build successfully on the 2nd attempt, I think that the problem could be in the port, that should be marked as jobs unsafe.
 
You must log in or register to reply here.
Back
Top