Hi,
I use D-Link 502-T Router through USB on most Linux distributions. While installing Free BSD 7.1 the installation utility could not detect the Router through USB, therefore, I temporarily connected it through Ethernet. After installation I tried the Router through USB but 'dmesg | tail' tells me that it was detected as 'ugen0" but no driver got loaded to use it as "Ethernet on USB".
On Linux "cdc_ether" and other required modules get loaded automatically for this router when plugged in USB port. For Free BSD I plugged it in before start-up.
I googled to get the information for the required module on Free BSD and tried 'kldload umodem' but it does not work.
My ethernet cable is not good quality and I prefer to use the router through USB.
Please help me set-up the router through USB.
kagashe
I use D-Link 502-T Router through USB on most Linux distributions. While installing Free BSD 7.1 the installation utility could not detect the Router through USB, therefore, I temporarily connected it through Ethernet. After installation I tried the Router through USB but 'dmesg | tail' tells me that it was detected as 'ugen0" but no driver got loaded to use it as "Ethernet on USB".
On Linux "cdc_ether" and other required modules get loaded automatically for this router when plugged in USB port. For Free BSD I plugged it in before start-up.
I googled to get the information for the required module on Free BSD and tried 'kldload umodem' but it does not work.
My ethernet cable is not good quality and I prefer to use the router through USB.
Please help me set-up the router through USB.
kagashe