Hi,
I have problems to get apache22 up and running. It was previously working without any problems, after rebooting the server it wont start up. I didn't change anything in the /usr/local/etc/apache22/httpd.conf.
When I run [CMD=""]apachectl start[/CMD]
I get following messages:
I am running apache22 inside of a jail.
Also on the hostsystem side I have enabled accf_http via
in /boot/loader.conf
Any ideas where to start looking for errors, I have checked logs but I can't find anything about the problem from there.
Best Regards
Folivora
I have problems to get apache22 up and running. It was previously working without any problems, after rebooting the server it wont start up. I didn't change anything in the /usr/local/etc/apache22/httpd.conf.
When I run [CMD=""]apachectl start[/CMD]
I get following messages:
Code:
/usr/local/etc/rc.d/apache22: DEBUG: checkyesno: apache22_http_accept_enable is set to NO.
/usr/local/etc/rc.d/apache22: DEBUG: pid file (/var/run/httpd.pid): not readable.
/usr/local/etc/rc.d/apache22: DEBUG: checkyesno: apache22_enable is set to YES.
/usr/local/etc/rc.d/apache22: DEBUG: run_rc_command: restart_precmd: apache22_checkconfig
Performing sanity check on apache22 configuration:
Syntax OK
/usr/local/etc/rc.d/apache22: DEBUG: pid file (/var/run/httpd.pid): not readable.
/usr/local/etc/rc.d/apache22: DEBUG: checkyesno: apache22_enable is set to YES.
apache22 not running? (check /var/run/httpd.pid).
/usr/local/etc/rc.d/apache22: DEBUG: pid file (/var/run/httpd.pid): not readable.
/usr/local/etc/rc.d/apache22: DEBUG: checkyesno: apache22_enable is set to YES.
/usr/local/etc/rc.d/apache22: DEBUG: run_rc_command: start_precmd: apache22_prestart
Performing sanity check on apache22 configuration:
Syntax OK
/usr/local/etc/rc.d/apache22: DEBUG: checkyesno: apache22limits_enable is set to NO.
Starting apache22.
/usr/local/etc/rc.d/apache22: DEBUG: run_rc_command: doit: /usr/local/sbin/httpd -DNOHTTPACCEPT
/usr/local/etc/rc.d/apache22: WARNING: failed to start apache22
I am running apache22 inside of a jail.
Also on the hostsystem side I have enabled accf_http via
Code:
accf_http_load="YES"
Any ideas where to start looking for errors, I have checked logs but I can't find anything about the problem from there.
Best Regards
Folivora