Building mod_php55 with Zts support

B

balanga

I was building mod_php55 earlier today and a dialogue box popped up where I could select various options, one of which was Zts. This was not highlighted, and never having heard of it before I just accepted the default. Immediately afterwards a warning appeared explaining some incompatibility with Apache, so I thought there might be some option to go back and alter my choices, but there wasn't and so mod_php55 was successfully built but without Zts support. I thought I would be able to rebuild the package if I ran make deinstall clean followed by make install clean, but the second time no dialogue box popped up. Where were my initial options saved and how can I start again from scratch and select the Zts option?
 
Re: Building mod_php55 with Ztr support

balanga said:
Where were my initial options saved and how can I start again from scratch and select the Ztr option?
Click to expand...
Yes, they are. You can remove the options with make rmconfig or change them with make config. See ports(7).
 
Re: Building mod_php55 with Ztr support

This post should have mentioned Zts support rather than Ztr support. Apologies for that.

rmconfig did what you suggested, but now I'm not sure if my php is incompatible with Apache... How do I tell if I built Apache with the same options?
 
Re: Building mod_php55 with Ztr support

balanga said:
How do I tell if I built Apache with the same options?
Click to expand...
pkg info apache24 should show the options that were used to build it.
 
You must log in or register to reply here.
Back
Top