acd0: FAILURE - INQUIRY ILLEGAL REQUEST

maxrussell

New Member


Messages: 6

I'm trying to get k3b to work on 7.0 release.

I've compiled atapicam support, but still no devices are seen.

dmesg reports the following:

Code:
hptrr: no controller detected.
ad0: 152627MB <Maxtor 6G160P0 KA201V00> at ata0-master UDMA133
acd0: DVDR <PIONEER DVD-RW DVR-111D/1.19> at ata1-master UDMA66
acd1: DMA limited to UDMA33, device found non-ATA66 cable
acd1: DVDROM <ASUS DVD-E616A2/1.03> at ata1-slave UDMA33
pcm0: <HDA Codec: Realtek ALC888>
pcm0: <HDA Driver Revision: 20071129_0050>
acd0: FAILURE - INQUIRY ILLEGAL REQUEST asc=0x24 ascq=0x00 sks=0x48 0x00 0x01
acd1: FAILURE - INQUIRY ILLEGAL REQUEST asc=0x24 ascq=0x00 
acd0: FAILURE - INQUIRY ILLEGAL REQUEST asc=0x24 ascq=0x00 sks=0x48 0x00 0x01
acd1: FAILURE - INQUIRY ILLEGAL REQUEST asc=0x24 ascq=0x00 
cd0 at ata1 bus 0 target 0 lun 0
cd0: <PIONEER DVD-RW DVR-111D 1.19> Removable CD-ROM SCSI-0 device 
cd0: 66.000MB/s transfers
cd0: Attempt to query device size failed: NOT READY, Medium not present
cd1 at ata1 bus 0 target 1 lun 0
cd1: <ASUS DVD-E616A2 1.03> Removable CD-ROM SCSI-0 device 
cd1: 33.000MB/s transfers
cd1: Attempt to query device size failed: NOT READY, Medium not present - tray closed
The device plays cds fine, but I can't set up k3b to use it.
 

DutchDaemon

Administrator
Staff member
Administrator
Moderator
Developer

Reaction score: 2,809
Messages: 11,288

I don't think the 'Illegal Request' errors are related to your problem. I get that every time I boot up without a CD in the tray. It looks like a complicated way of saying 'nothing to play, boss'.
 

adamk

Daemon

Reaction score: 266
Messages: 1,622

What do you mean you "can't set up k3b to use it."? What error messages are you getting? /dev/cd0 is clearly created and should work:

cd0: <PIONEER DVD-RW DVR-111D 1.19>

Do you have permission to access the /dev/cd0 device?

Adam
 

Mel_Flynn

Well-Known Member

Reaction score: 81
Messages: 379

K3b needs access to the xpt device that is connected to the writer and people should really read post-install messages. In k3b case, type this to view the instructions:
Code:
make -C /usr/ports/sysutils/k3b showinfo
It is detailed and shows exactly what to do.
Also, if you run kde via kdm, your ~/.xsession-errors would have shown failure to open the xpt device. Or in a xterm/konsole/yourfavterminal it would've shown up as well.
 
Top