ntpq

I'm trying to use ntpd to set the correct time on a machine. I have setup the service by adding these two lines in /etc/rc.conf: ntpd_enable="YES" ntpd_sync_on_start="YES" Then i ran service ntpd start to start the service. The thing I can't figure out is how to see that the time has been...

I have configured ntp.conf to have four servers to synchronize with. When I run # ntpq -pn remote refid st t when poll reach delay offset jitter ============================================================================== 36.105.58.17 .INIT. 16 u -...