I created a ng_bridge with link0 and link1 connected to my physical devices lower and upper.
I then created a bhyve VM with a netgraph virtio-net device that is connected to link2.
Here is `ngctl dot` to help visualize it:
Here is ngctl commands I issued:
msg re0: setpromisc 1
I'm currently dealing with an intriguing situation that involves the Netgraph and its interaction within a FreeBSD Jail configured with VNET.
I have loaded the ng_ether module on the host machine. Additionally, I have set up multiple FreeBSD Jails with VNET and they are...
I am setting up a FreeBSD server to act as a router/firewall for an ISP that is experiencing a DDoS attack.
All services are up and running smoothly, but now I need to configure a flow packet exporter for an attack detector to monitor link turnovers and take real-time protection...
Any netgraph gurus out there?
I created two vnet jails with the help of the devin teske's jng scipts and example jail.conf under /usr/share/examples/jails/.
I can enter either jail using jexec
However, I cannot ping any targets from inside the jails. The jails do not appear to have ip...
I have a question about MTU of jail vimage by netgraph.
Please reference illustration of running system as follows.
Running routing mode with gateway_enable="YES" @ /etc/rc.conf.
Connect Jail of ssh from netif msk0(internet) via ssh.
Log in is OK, but disconnect unexpected when high...
I am using a bridge `bridge0` that will contain a native nic interface ixl3 and add a tap interface in it:
ifconfig bridge0 create
ifconfig bridge0 addm ixl3 addm tap0
bridge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
I'm struggling with ngctl to enable SO_REUSEPORT on ksocket(inet/dgram/udp).
Node ID as absolutely correct, I can both bind and connect - but I can't setopt.
# node: is of type ksocket inet/dgram/udp
ngctl msg node: bind inet/127.0.0.1:5000
ngctl msg node: connect...
I'm in the process of writing a netgraph node specific to my project, sitting between ethernet node on the left and bunch of udp/sctp nodes on the right (sorta really crippled L2 VPN without encryption). It has "local" and set of peer0..peer15 hooks.
The job of the node with flow...
My server upgrade to 12.0-Release and found news about VIMAGE into GENERAL config, meant VIMAGE ready for product environment.
So I wish to migrate exist ordinary jail to VIMAGE infrastructure too :).
But procedure stopped at default gateway.
Current ordinary jail environment detail...
On my home network I have three VirtualBox VMs that I would like to condense into a single VM, this single VM would have three jails each running a service.
Currently each VM has a VirtualBox bridged adaptor, on my router I see each VM having its own MAC address, and the router...