error 19

I've compile the kernel with this conf in vmware workstation, [root@FreeBSD14 ~]# cat SEC cpu HAMMER device acpi device aesni # AES-NI OpenCrypto module device bpf # Berkeley packet filter device ch...

I've recently installed FreeBSD on windows xp desktop,it worked fine in the beginning but in the middle it said error 19 , and no matter what i type it always says invalid syntax,i have tried the hostress method still invalid syntax.Please help.

The other day I had a disc go bad in one of my mirrors. I'm now trying to format and integrate its replacement. But if I add the disc to the system, I can't boot. FreeBSD gets lost and becomes unable to figure out where root is or how to mount it, even though it's (of course!) on the same...

When I run bhyve (FreeBSD guests) the following errors occured. bhyve -c 1 -m 1G -A -H -P -s 0:0,hostbridge -s 1:0,virtio-net,tap0 -s 2:0,virtio-blk,/data/vm.img -s 31,lpc -l com1,/dev/nmdm0A vm Unhandled ps2 mouse command 0xe1 Durng vm boot. module_register_init: MOD_LOAD (vesa...

Ok Im going to try to be as detailed as possible, I'm running Freebsd 9.2. I started this adventure with two drive, a system drive and a second 3TB drive which mounted to /secDsk. My end goal was to install a new 8TB drive, copy all the data from the 3TB drive to the new 8TB drive. Then remove...

Hi all, I'm trying to boot FreeBSD 10.2 from a USB device that I used as the install destination from a liveCD installer. I performed the installation on another system, specifying the flash disk (Patriot XPorter 16GB) as the install target and am now trying to boot a small fileserver from...