ata

Below, why are there log entries for PIIX3 when the controller is set to PIIX4? I have been trying (amongst other things) to boot this 12.⋯ guest temporarily in safe mode. Neither of the commands below seem to be effective – note the multiple CPUs, above, in htop: nextboot -o...

Hello everyone! (To admins: if you feel there is a better place for this thread, go ahead and move it.) During my new attempt to recompile the kernel for my old ThinkPad X31 laptop I have left the following lines for minimal ATA support (without dozens of unneeded controllers): device atacore...

Hi all. I got repeated message like below. ata0: timeout waiting to issue command ata0: error issuing SMART RETURN STATUS command ata0: timeout waiting to issue command ata0: error issuing SMART RETURN STATUS command ata0: timeout waiting to issue command ata0: error issuing SMART RETURN...

I'm trying to spindown disks in a zpool to save energy costs. This concerns a home NAS setup. I've broken in down to a single disk. Here I want the disk to go into standby mode after 20 minutes of idle time: camcontrol standby ada2 -t 1800 What actually happens is the disk spins down...

How can I grab the hard drive serial number in C on a machine running FreeBSD? The hard drive in question is an mSATA SSD. Specifically the TS256GMSA370. In my searching I found the following on this forum: 9548 I receive the error 'Inappropriate ioctl for device' when running the following...