Search results

Done. 219384 It is my first PR. I hope it is ok.

Same problem on my old Intel S3000AH board based on Intel 3000 chipset. none1@pci0:4:0:3: class=0x070002 card=0x00008086 chip=0x108f8086 rev=0x03 hdr=0x00 vendor = 'Intel Corporation' device = 'Active Management Technology - SOL' class = simple comms subclass...

Same problem on FreeBSD 8.2-RELEASE :(

Does this mean that I don't require print/hplip to install? foo2zjs driver is already intalled on my system. Followed instruction for FreeBSD 8.0 from http://foo2zjs.rkkda.com/INSTALL but after setup of printer in CUPS and sending "Test Page" to it nothing happens. In the instruction is...

Does anyone have this printer working under FreeBSD 8.1? I've installed cups, hplip & foo2zjs but no luck. Hp-check & /usr/local/libexec/cups/backend/hp found nothing. Does this printer require firmware to work like HP 1005 for example? usbconfig dump_device_desc returns: ugen1.2: <HP...

Hi again. Successfully solved the problem by compiling new kernel without any options and devices i don't have. Can't understand how it helps but the system is working now! p.s. don't know how to rename the topic to [Solved] prefix

As i can see the boot process gone till this line: orm0: <ISA Option ROM> at iomem 0xc0000-0xc8fff on isa0. Maybe here is the problem?

pciconf -lv hostb0@pci0:0:0:0: class=0x060000 card=0x348e8086 chip=0x27788086 rev=0x00 hdr=0x00 vendor = 'Intel Corporation' device = 'E7230/3000/3010 Processor to I/O Controller' class = bridge subclass = HOST-PCI pcib1@pci0:0:28:0: class=0x060400 card=0x27d08086...

Here is /var/run/dmesg.boot and pciconf -lv without controller installed: /var/run/dmesg.boot Copyright (c) 1992-2009 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD is a...

After this pause the boot process continue only to the lines in my first post. In the other PCI-E x8 slot the same problem occur (NMI ISA b0, EISA 0, other lines are the same as in first post). So I can only post the results of pciconf & dmesg.boot without controller installed in the system...

I don't think the problem is in memory. I tried to boot only with two modules, but the boot process stoped at the same place. Only removing of Intel controller helps. When i boot with controller installed the process pause for about 5 seconds after loading mpt driver. Is this normal? p.s...

Hello all. I have a problem while running the installation of FreeBSD-Release 8.0 (FreeBSD-Release 7.2 too) on my system. Main components are: MB - Intel S3000AH CPU - Intel Pentium Dual Core E2140 RAM - 6 GB with ECC Controller - Intel SASWT4I (the same as LSI 3041E-R) on LSI...

phoenix Could you suggest someone that is supported in 8.0-Release? What about 8204ELP? Would like to make raid-z zpool via cheap LSI controller & Intel expanders (AXX6DRV3GEXP & AXX4DRV3GEXP) P.S. MB is Intel S3000AH & Case SC5300