X.Org will not start after default install

micski

micski

I made a clean install of 64 bit FreeBSD, updated ports with portsnap and compiled X.Org. The hardware is an Intel Core i5-2500 with integrated Intel HD 2000 graphics and two DVI/VGA connected Samsung SyncMaster 2443's.

I followed the handbook instructions. However, X.Org will not start. A manual probe for hardware writes a new configuration. However, this configuration does not show the recognition/use of the Intel driver nor any Samsung monitors.

I also tried the RandR hardware probe tool. It just returns a message, that it can not open display, whatever that means.

Any hints?
 
If I manually load the Intel driver, the following messages appear.

X.Org log probe the following.
Code: 
(--) PCI:*(0:0:2:0) 8086:0102:1458:d000) Intel Corporation 2nd Generation Core Processor Family Integrated Graphics Controller rev 9...
The X.Org error message is as follows.
Code: 
Fatal server error:
no screens found
 
You must log in or register to reply here.
Back
Top