Hello, I'm having trouble seeing disks properly in 10-Release with XENHVM support. I spawned an HVM domU with 3 local disks while PCI passing through a JBOD with 4 disks. They're appearing as follows;
host disks - FreeBSD domu
/dev/sdc5 - ada0
/dev/sda - ada1
/dev/sdb - ada2
PCI Passthrough - eSATA card connected to a JBOD with 4 disks (this is basically a ZFS pool previously connected to a physical host now being virtualized);
ada0
ada1
ada2
ada3
Please see attached.
Can I force tell FreeBSD to recognize these disks differently?
Thanks.
PS: the setup works - even zpool() starts - but I see device name errors in
host disks - FreeBSD domu
/dev/sdc5 - ada0
/dev/sda - ada1
/dev/sdb - ada2
PCI Passthrough - eSATA card connected to a JBOD with 4 disks (this is basically a ZFS pool previously connected to a physical host now being virtualized);
ada0
ada1
ada2
ada3
Please see attached.
Can I force tell FreeBSD to recognize these disks differently?
Thanks.
PS: the setup works - even zpool() starts - but I see device name errors in
dmesg
. I guess the point is to not see same device names for different disks.