1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Ralink USB RT3070 (if_run) and wpa_supplicant

Discussion in 'Networking' started by dfa, Jan 30, 2012.

  1. dfa

    dfa New Member

    Messages:
    1
    Thanks Received:
    0
    In FreeBSD 8.2 this works:

    Code:
    ifconfig wlan0 create wlandev run0 up
    ifconfig wlan0 list scan
    (displays access points)
    wpa_supplicant -i wlan0 -c wpa_supplicant.conf -dd
    


    In FreeBSD 9.0 and CURRENT wpa_supplicant writes:

    Code:
    Try to find WPA-enabled AP
    Try to find non-WPA AP
    No suitable network found
    


    Before wpa_supplicant is started, 'list scan' displays some access points. Afterwards it doesn't display them. Even when I stop wpa_supplicant and execute ifconfig wlan0 up.

    Device:
    Code:
    Jan 30 18:57:54 rechner1 kernel: run0: MAC/BBP RT3070 (rev 0x0201), RF RT3020 (MIMO 1T1R), address <mac-address>
    Jan 30 18:57:54 rechner1 kernel: run0: firmware RT2870 loaded
    


    Should I fill in a bug report? What logs do you require?

    Thank you very much for your help.
     
  2. jb_fvwm2

    jb_fvwm2 Active Member

    Messages:
    1,610
    Thanks Received:
    161
    No idea, but searching the forum for syncdhcp has a lot of threads one of which may help...