ipfw traffic shaping

alexus · #1 October 9th, 2009, 18:00

I have following rules:

Code:

pipe 1 config bw 1Mbit/s
add 8380 pipe 1 tcp from any to any src-port www
add 8380 pipe 1 tcp from any to any dst-port www

yet my MRTG show's way more traffic then just 1Mbit/s

can someone help me?

kenbukan · #2 October 13th, 2009, 13:57

Hello i have the same problems try

Code:

pipe 1 config bw 10Kbit/s

i don't know where is the bug.

alexus · #3 October 13th, 2009, 16:27

Quote:

Originally Posted by kenbukan

Hello i have the same problems try

Code:

pipe 1 config bw 10Kbit/s

i don't know where is the bug.

I don't understand, are you asking me to try it as it as a solution for my issue? or as you showing me what you doing and it's similar to mine?

kenbukan · #4 October 14th, 2009, 11:26

Hello alexus,

i use two Gbit ethernet cards as bridge and to shape the traffic of this, if i use

Code:

ipfw pipe 1 config bw 10Mbit/s

the traffic is more than 10Mbit/s.

If i use

Code:

ipfw pipe 1 config bw 100Kbit/s

the traffic is shaping of 10Mbit/s

But the bridge is break after 2 minutes.

alexus · #5 October 14th, 2009, 17:19

do ipfw pipe show

Pushrod · #6 October 16th, 2009, 13:59

Use different pipes for in and out.

alexus · #7 October 16th, 2009, 15:09

isn't when i don't specify it goes both ways?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[FreeBSD + PF cbq + borrow] Dynamic shaping	Denok	Firewalls	16	August 19th, 2010 16:34
Traffic Shaping - pf Rule Review	Ruler2112	Firewalls	1	October 13th, 2009 21:03
Traffic Shaping - Bandwidth per Port?	Ruler2112	Networking	6	September 24th, 2009 23:36
ISP Software, RADIUS, Traffic Shaping, Squid	esz	Web & Network Services	2	July 20th, 2009 22:53
ipfw and traffic shaper	xer	Firewalls	3	July 17th, 2009 07:38