Hey all,
Having a bit of an issue getting a NIC to work. It's a Sun card, uses the CAS drivers. When the driver loads, the system hangs with error:
Does the same thing whether I load the driver as a module or compile it into the kernel. I assumed there may be a driver conflict, so build a very minimal kernel, but no joy. Oddly, this is a somewhat intermittent issue. Once in a while, I can boot and the CAS driver loads fine.
Also, if I load it manually with kldload it will sometimes work, then not. But if I manually load, then unload, then load again, it works! This has been a head scratcher for me for a few days now. Grateful for any suggestions =)
If it matters, this is a PCI-X card on a Supermicro mobo.
Thanks!
Having a bit of an issue getting a NIC to work. It's a Sun card, uses the CAS drivers. When the driver loads, the system hangs with error:
Code:
cas0: attaching PHYs failedDoes the same thing whether I load the driver as a module or compile it into the kernel. I assumed there may be a driver conflict, so build a very minimal kernel, but no joy. Oddly, this is a somewhat intermittent issue. Once in a while, I can boot and the CAS driver loads fine.
Also, if I load it manually with kldload it will sometimes work, then not. But if I manually load, then unload, then load again, it works! This has been a head scratcher for me for a few days now. Grateful for any suggestions =)
If it matters, this is a PCI-X card on a Supermicro mobo.
Thanks!