Search results

  1. S

    Dummynet

    Thanks Ecazamir, Yes, probably it was the error. Thanks,
  2. S

    Dummynet

    Hello, I've continued testing and I've changed the IP 10.192.192.5/24 to 192.168.27.3/32. This was my test: Dummynet: em0 10.10.40.1/24 I've added a static route with this command: route add -net 192.168.27.3/32 10.10.40.1 Vyatta: eth0 interface 10.10.40.2/24 eth0 interface IP secondary...
  3. S

    Dummynet

    Hello, I've put down the NAT and am testing just between Dummynet and Vyatta with these 2 tests: FIRST TEST Dummynet: em0 10.10.40.1/24 I've added a static route with this command: route add -net 10.192.192.0/24 10.10.40.1 Vyatta: eth0 interface 10.10.40.2/24 eth0 interface IP secondary...
  4. S

    Dummynet

    Hello ecazamir, This is the link of the second image http://www.wanopt.net/Configuration_vyatta%20NAT.jpg I'll follow your suggestion, to check the NAT first and then, use the commands to do troubleshooting. I'll post then. Thanks,
  5. S

    Dummynet

    Hello, As I've written others posts, I'm doing a virtual laboratory to test WAN Optimization. I've installed Vyatta on VMware EXSi 5.0. This is the network diagram: http://www.wanopt.net/Lab_WANOptimization_final.jpg I've configured static NAT so the server's IP address is...
  6. S

    [IPFW] Issues with pipe

    Hi Phoenix, I removed the general rule and applied the following commands and now, it is working. ipfw add 100 pipe 1 ip from 10.10.20.0/24 to 10.10.40.0/24 ipfw pipe 1 config bw 10000kbit/s delay 0ms Thanks so much!
  7. S

    [IPFW] Issues with pipe

    Hello, I'm doing a laboratory to test some virtual WAN optimization equipments. This is the diagram of my network: I installed a VMWare image with FreeBSD and DummyNet already set up and also, I put off the WAN Optimization equipments to test the WAN simulator - Dummynet and then, I have...
  8. S

    ipfw: setsockopt(IP_DUMMYNET_CONFIGURE): Protocol not available

    Thanks phoenix, I have installed another VMWare image with FreeBSD and DummyNet already set up and now, I can configured the ipfw and pipes. However, I'm facing another problem with the pipes so I'll post another thread for that. Thanks, [ Cont'd at 31398 -- Mod. ]
  9. S

    ipfw: setsockopt(IP_DUMMYNET_CONFIGURE): Protocol not available

    Hello, I need to set up DummyNet and I've followed these steps: Add the following lines to /etc/rc.conf: firewall_enable="YES" firewall_type="OPEN" Create a rule Example: ipfw add 1000 allow all from any to any Create the pipes Example: ipfw add 100 pipe 1 ip from any to any Set up the...
Back
Top