PDA

View Full Version : no sound from amarok


ser
December 15th, 2009, 19:37
I've installed amarok on KDE 4.3.4 (FreeBSD 8.0) but it doesn't play anything
Everything is fine with xmms2, mplayer also works fine

I have error messages like this then I try to change a volume:
> mixer speaker 100
Setting the mixer speaker from 0:0 to 100:100.
mixer: WRITE_MIXER: Device not configured

Some output:
> cat /dev/sndstat
FreeBSD Audio Driver (newpcm: 32bit 2009061500/i386)
Installed devices:
pcm0: <Envy24HT audio (Generic)> at io 0xc000:32,0xc100:128 irq 20 [GIANT] (1p:1v/3r:1v channels duplex default)

dmesg:
pcm0: <Envy24HT audio (Generic)> port 0xc000-0xc01f,0xc100-0xc17f irq 20 at device 0.0 on pci6
pcm0: [GIANT-LOCKED]
pcm0: [ITHREAD]
pcm0: system configuration
SubVendorID: 0x1412, SubDeviceID: 0x2401
XIN2 Clock Source: 49.152MHz(192kHz*256)
MPU-401 UART(s) #: 1
ADC #: 1
DAC #: 3
Multi-track converter type: I2S(48KHz support, 24bit resolution, ID#0x0)
S/PDIF(IN/OUT): 1/1 ID# 0x00
GPIO(mask/dir/state): 0xff/0xff/0xff

Thanx in advance

aragon
December 15th, 2009, 22:39
What about one of these:


mixer vol 100
mixer pcm 100


Also, what is the output of mixer without any arguments?

ser
December 16th, 2009, 18:02
Everything's fine with mixer vol and mixer pcm, I can change them.

But I think the reason is in the default output plugin in KDE, because then I launch Amarok under e17 it's working fine. I suppose with OSS Amarok should play music, but I still didn't find any options where I can change it

sixtydoses
December 16th, 2009, 22:18
Settings > Configure Amarok > Playback > Sound System Configuration > Configure?

ser
December 17th, 2009, 07:09
:) I thought it should be like this, but I have no options in Playback > Configure (don't have Sound System Configuration there), just blank page. I reinstalled Amarok with all ports it requires but with no luck